9. Connect the display cable to the system board and close the latch the secure the cable.
10. Place the wireless-card bracket on the wireless card.
The following table provides the antenna-cable color scheme for the wireless card that is supported by your computer.
Table 2. Antenna-cable color scheme
Connectors on the
wireless card
Antenna-cable color Silkscreen marking
Main White MAIN △ (white triangle)
Auxiliary Black AUX ▲ (black triangle)
11. Replace the screw (M2x2.5) that secures the wireless-card bracket to the system board.
12. Align the screw hole on the left display hinge to the screw hole on the system board.
13. Replace the screw (M2x3) that secures the left display hinge to the system board.
Next steps
1. Install the solid state drive.
2. Install the heat sink.
3. Install the fan.
4. Install the 4-cell battery or the 3-cell battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 4-cell battery or the 3-cell battery.
4. Remove the speakers.
5. Remove the display assembly.
6. Remove the power-adapter port.
7. Remove the touchpad.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the removal
procedure.
Removing and installing components
49
To Next Page
Loading...
