About this task
The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1. Lift the mylar that covers the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (as indicated on the heat sink), tighten the seven captive screws that secure the heat sink to the system
board.
NOTE: The number of screws varies depending on the configuration ordered.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
38
Removing and installing components
To Next Page
Loading...
