Steps
1. Remove the screw (M2x3) that secures the left display hinge to the system board.
2. Lift the left display hinge away from the system board.
3. Lift the Mylar that covers the wireless card.
4. Remove the screw (M2x2.5) that secures the wireless-card bracket to the system board.
5. Lift the wireless-card bracket off the system board.
6. Disconnect the antenna cables from the system board.
7. Lift the Mylar that covers the display cable.
8. Open the latch, and disconnect the display cable from the system board.
9. Peel off the tape that adheres the power-adapter port cable to the system board.
10. Disconnect the power-adapter port cable from the system board.
11. Lift the Mylar that covers the cable connectors on the system board.
12. Disconnect the coin-cell battery cable from the system board.
13. Open the latch, and disconnect the fingerprint-reader cable, I/O-board cable, touchpad cable, keyboard cable and keyboard-
backlit cable from the system board.
14. Disconnect the speaker cable from the system board.
15. Lift the system board off the palm-rest and keyboard assembly.
Removing and installing components
45
To Next Page
Loading...
