3. Cover the memory module with the Mylar.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
M.2 2230 solid-state drive
M.2 2242 solid-state drive
Removing and installing components
19
To Next Page
Loading...
