About this task
The following image indicates the location of the solid-state drive screw mount and provides a visual representation of the
procedure to move the screw mount to another location that accommodates the form factor.
Steps
1. Slide the screw mount out of the screw-mount slot on the palm-rest and keyboard assembly.
2. Turn the screw mount 180 degrees.
3. Insert the screw mount into the other screw-mount slot on the palm-rest and keyboard assembly.
4. To move the screw mount to the screw-mount slot where it had originated from, reverse the steps.
Installing the solid-state drive
Prerequisites
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
M.2 2230 solid-state drive
Removing and installing components
21
To Next Page
Loading...
