Steps
1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
3. Connect the power-adapter cable to the connector on the system board.
Next steps
1. Install the display assembly.
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Power button
Removing the power-button board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the fan.
About this task
The following image indicates the location of power button and provides a visual representation of the removal procedure.
Removing and installing components
45
To Next Page
Loading...
