Steps
1. Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system
board.
2. In sequential order (following the numeral markings on the heat sink, from 1 to 7), tighten the seven captive screws that
secure the heat sink to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
Removing and installing components
41
To Next Page
Loading...
