Dell Inspiron 560s - Replacing the Front I;O Panel


1. Follow the procedures in Before You Begin.

2. Route and connect the cables that you disconnected from the system board connectors.

3. Align and slide the front I/O panel into the front I/O panel clamp slot.

4. Replace the screw that secures the front I/O panel to the chassis.

5. Replace the hard drive (see Replacing the Hard Drive).

6. Replace the support bracket (see Replacing the Support Bracket).

7. Replace the front bezel (see Replacing the Front Bezel).

8. Replace the computer cover (see Replacing the Computer Cover).

9. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page

CAUTION: Take care not to damage the cable connectors and the cable routing clips when sliding the front I/O panel into the front I/O panel
clamp slot.