Dell Inspiron 560s - Support Bracket; Removing the Support Bracket; Replacing the Support Bracket

Back to Contents Page
 Support Bracket
Dell™Inspiron™560sServiceManual
Removing the Support Bracket
Replacing the Support Bracket



Removing the Support Bracket

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Pull back the support-bracket release latch and pivot the support bracket up.

4. Lift the support bracket off the hinge-tab slots and set it aside in a secure place.
Replacing the Support Bracket

1. Follow the procedures in Before You Begin.

2. Align and insert the hinge tabs at the bottom of the support bracket into the hinge-tab slots located along the edge of the computer.

3. Pull back the support-bracket release latch and pivot the support bracket downward, until the support-bracket release latch locks into place.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
1
support-bracket release latch
2
hinge-tab slots (2)
3
hinge tabs (2)
4
support bracket