Adding and Replacing Parts 83
3
Remove the existing modem:
a
Remove the screw securing the modem to the system board, and set it aside.
b
Pull straight up on the attached pull-tab to lift the modem out of its connector on the
system board, and disconnect the modem cable.
4
Install the replacement modem:
a
Connect the modem cable to the modem.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the
connectors and realign the card.
b
Align the modem with the screw holes and press the modem into the connector on the
system board.
c
Replace the screw that secures the modem to the system board.
5
Replace the modem cover.
modem
system board connector
screw
modem cable
pull-tab
To Next Page
Loading...
