Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the coin-cell battery.
5. Remove the memory modules.
6. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
7. Remove the fan.
8. Remove the I/O board.
9. Remove the speakers.
10. Remove the heat sink.
11. Remove the touchpad.
12. Remove the power-adapter port.
13. Remove the power-button board.
14. Remove the fingerprint reader daughter-board.
15. Remove the display assembly.
16. Remove the pen-garage cable.
17. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
Steps
After performing the steps in the pre-requisites, you are left with the palm-rest and keyboard assembly.
56
Removing and installing components
To Next Page
Loading...
