Replacing the display assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
CAUTION:
Place the computer on a soft and clean surface to avoid scratching the display.
1. Place the display assembly on the palm-rest assembly. Align the screw holes on the display hinges with the screw holes on the I/O
board and system board.
2. Replace the four screws (M2.5x4) that secure the display hinges to the I/O board and system board.
3. Close the display.
Removing and installing components
47
To Next Page
Loading...
