b. Ensure that the slider is inserted so that the side with the two bumps is
facing the back of the bottom case, and the surface with the wear ribs lies
against the upper surface of the bottom case.
7. Hold the upper latch assembly in place while you snap the new latch button in
from underneath the bottom case, making certain the snap tabs are fully
engaged in the slider.
Ensure that the newly installed latch assembly moves smoothly and freely when
pushed and released.
Back to Contents Page
file:///F|/Service%20Manuals/Dell/Inspiron/8200/baylatch.htm (3 of 3) [2/28/2004 7:40:58 AM]
To Next Page
Loading...
