2 center control cover
3 computer base
3. Remove the center control cover:
a. Open the display all the way (180 degrees) so that it lies flat against your work surface.
b. Starting on the left side of the computer, use a plastic scribe or flat-blade screw driver to
pry up the center control cover.
c. Disconnect the center-control-cover flex cable from the system board connector using
the pull-tab.
d. Lift the center control cover away from the computer, and lay it aside.
1 center control cover
2 system board connector
4. Remove the keyboard:
a. Remove the two M2.5 x 6-mm screws across the top of the keyboard.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS...T%20PARALLEL%20SERIAL_SERV_MAN/keyboard.htm (2 of 3)6/21/2004 1:14:19 AM
To Next Page
Loading...
