1 system board
2 speaker connector
3 speakers
Installing the System Board
1. Perform all the steps in "Removing the System Board" in reverse order.
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws
remain inside the computer. Failure to do so may result in damage to the computer.
2. Turn on the computer.
NOTE: After replacing the system board, enter the computer Service Tag into the BIOS of the
replacement system board.
3. Insert the floppy disk or CD that accompanied the replacement system board into the
appropriate drive. Follow the instructions that appear on the screen.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS...T%20PARALLEL%20SERIAL_SERV_MAN/sysboard.htm (5 of 6)6/21/2004 1:14:24 AM
To Next Page
Loading...
