Antenna-In Connector: Dell Inspiron One 2305/2310 Service Manual
file:///T|/htdocs/systems/InsOne2310/sr/sm/tvin.htm[7/25/2012 10:24:51 AM]
Back to Contents Page
Antenna-In Connector
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Antenna-In Connector
Replacing the Antenna-In Connector
WARNING: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to
servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on your computer).
Removing the Antenna-In Connector
1. Follow the instructions in Before You Begin.
2. Remove the back cover (see Removing the Back Cover
).
3. Follow the instructions from step 2
to step 5 in Removing the Front Stand.
4. Follow the instructions from step 4
to step 8 in Removing the System-Board Shield.
5. Remove the hex nut that secures the antenna-in connector to the system-board shield.
6. Release the antenna-in connector from the slot on the system-board shield.
7. Lift the antenna-in connector along with its cable away from the system-board shield.
1 antenna-in connector 2 hex nut
To Next Page
Loading...
