Antenna-In Connector: Dell Inspiron One 2305/2310 Service Manual
file:///T|/htdocs/systems/InsOne2310/sr/sm/tvin.htm[7/25/2012 10:24:51 AM]
Replacing the Antenna-In Connector
1. Follow the instructions in Before You Begin.
2. Slide the antenna-in connector into the slot on the system-board shield.
3. Replace the hex nut that secures the antenna-in connector to the system-board shield.
4. Follow the instructions from step 4
to step 8 in Replacing the System-Board Shield.
5. Follow the instructions from step 4
to step 5 in Replacing the Front Stand.
6. Replace the back cover (see Replacing the Back Cover
).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain
inside the computer. Failure to do so may result in damage to the computer.
7. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
To Next Page
Loading...
