Dell Latitude 3340 2-in-1 - Chapter 2: Removing and installing components

Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover Captive 7
Battery Captive 5
M.2 solid-state drive M2x2
M2x3
1
1
Wireless-card M2x3 1
Fan M2x3 2
Display assembly M2.5x4 6
I/O board M2.5x4
M2x3
2
2
2
10 Removing and installing components