Steps
1. Align and place the coin-cell battery into its slot on the palm-rest and keyboard assembly.
2. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: The display assembly removal procedure is the same for both clamshell and 2-in-1 convertible chassis.
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing components
31
To Next Page
Loading...
