Steps
1. Align the notch on the memory module with the tab on the memory module slot.
2. Slide the memory module firmly into the slot at an angle.
3. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
M.2 solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to systems shipped with a M.2 2230 solid-state drive installed.
NOTE: The M.2 solid-state drive that is installed on your system depends on the configuration ordered. Supported card
configurations on the M.2 solid-state drive slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
Removing and installing components 21
To Next Page
Loading...
