Figure 21. Installing the speakers
.
Steps
1. Using the alignment posts and rubber grommets, place the speakers in their slots on the palm-rest and keyboard assembly.
2. Route the speaker cables through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the connector on the system board.
4. Ensure that the alignment posts are threaded through the rubber grommets on the speakers.
5. After placing the speakers on the palm-rest and keyboard assembly, ensure that rubber grommets are seated into the slot
and installed on the speakers correctly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
50
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
