Figure 29. Removing the heat-sink for integrated graphics
Steps
1. Loosen the four captive screws that secure the heat-sink to the system board in the reverse sequential order mentioned on
the heat-sink [4 > 3 > 2 > 1].
2. Lift and remove the heat-sink from the system board.
Installing the heat-sink for integrated graphics
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
If either the system board or the heat-sink is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following image indicates the location of the heat-sink and provides a visual representation of the installation procedure.
60
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
