Figure 52. Installing the display assembly
Steps
1. Place the display assembly on a flat surface.
2. Slide the display assembly at an angle and place the system chassis under the hinges of the display assembly.
3. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest
and keyboard assembly.
4. Replace the six screws (M2.5x5) to secure the display hinges to the palm-rest and keyboard assembly.
5. Route the WLAN antenna cables over the routing guides on the fan.
6. Connect the display cable to its connector on the system board.
7. Adhere the adhesive tape to secure the display cable.
Next steps
1. Install the wireless card.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
83
To Next Page
Loading...
