Figure 65. Installing the display panel
Steps
1. Place the display panel on flat and clean surface.
2. Connect the display cable to the connector on the display panel and close the latch.
3. Adhere the conductive tape to secure the display cable to the display panel.
4. Insert the display panel tabs into the slots on the display cover.
5. Replace the six (M2.5x2.5) screws to secure the display panel to the display back cover.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
93
To Next Page
Loading...
