3. Remove the base cover.
4. Remove the battery.
5. Remove the speaker.
6. Remove the memory module.
7. Remove the system fan.
8. Remove the DC-in .
9. Remove the WLAN card.
10. Remove the system board.
NOTE: System board can be removed with heatsink attached.
11. Remove the coin cell battery.
12. Remove the keyboard.
13. Remove the SmartCard reader.
About this task
After performing the preceding steps, you are left with the palmrest and keyboard assembly.
Next steps
1. Replace the SmartCard reader.
2. Replace the keyboard.
3. Replace the coin cell battery.
4. Replace the system board.
NOTE: System board can be replaced with heatsink attached.
5. Replace the WLAN card.
6. Replace the DC-in.
7. Replace the memory module.
8. Replace the system fan.
9. Replace the speaker.
114
Disassembly and reassembly
To Next Page
Loading...
