11. Disconnect the power button (with finger print reader) cable from the system board [1].
12. Disconnect the WWAN Darwin antennae cables [2] from the system board.
13. Remove the two (M2x4) screws [1] and lift up the USB Type-C bracket from the system board [2].
14. Remove the five (M2x4) screws [1] and remove the system board from the palmrest assembly [2].
NOTE:
For models shipped with a fingerprint reader or WWAN antennas, there are three (M2x3) screws securing the
system board to the computer.
70 Removing and installing components
To Next Page
Loading...
