NOTE: For computers shipped with a fingerprint reader, the power button includes a fingerprint reader module.
The following images indicate the location of the power button with optional fingerprint reader and provide a visual
representation of the removal procedure.
Steps
1. Remove the two screws (M1.2x1.5) that secure the power button to palm-rest and keyboard assembly.
2. Peel the fingerprint reader flexible printed circuits from the connector on the palm-rest and keyboard assembly.
NOTE: This step applies only to computers shipped with a power button with fingerprint reader installed.
3. Lift the power button off the slot on the palm-rest and keyboard assembly.
Installing the power button with optional fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button with optional fingerprint reader and provide a visual
representation of the installation procedure.
56
Removing and installing components
To Next Page
Loading...
