Table 6. System setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Set the operating mode of the integrated storage device controller.
By default, the RAID On option is enabled.
Storage Interface
Port Enablement This page allows you to enable the onboard drives.
By default, the M.2 PCIe SSD option is enabled.
SMART Reporting
Enable SMART Reporting Enable or disable Self-Monitoring, Analysis, and Reporting Technology
(SMART) during system startup.
By default, the Enable SMART Reporting option is not enabled.
Drive Information
Table 7. System setup options—Display menu
Display
Display Brightness
Brightness on battery power Enable to set screen brightness when the system is running on battery power.
Brightness on AC power Enable to set screen brightness when the system is running on AC power.
Touchscreen Enable or disable Touchscreen.
By default, the option is enabled.
NOTE: This option is available only for systems that support touchscreen.
Full Screen Logo Enable or disable full screen logo.
By default, the option is not enabled.
Table 8. System setup options—Connection menu
Connection
Wireless Device Enable
WWAN/GPS Enable or disable the internal WWAN/GPS device.
By default, the option enabled.
WLAN Enable or disable the internal WLAN device.
By default, the option enabled.
Bluetooth Enable or disable the internal Bluetooth device.
By default, the option enabled.
Contactless smart card/NFC Enable or disable the internal Contactless smart card/NFC device.
By default, the option enabled.
NOTE: This option is available only for systems that support Contactless
smart card/NFC.
Enable UEFI Network Stack Enable or disable UEFI Network Stack and controls the on-board LAN
Controller.
By default, the Enable UEFI Network Stack option is enabled.
Wireless Radio Control
70 BIOS setup
To Next Page
Loading...
