Removing optional VGA module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (M3X3) screws that secure the optional VGA module to the computer chassis.
2. Disconnect the VGA module cable from the connector on the system board.
3. Remove the VGA module from the computer.
Installing optional VGA module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the installation
procedure.
Removing and installing components
73
To Next Page
Loading...
