Dell OPTIPLEX 3010 Desktop - Installing the Input;Output Panel; Removing the Power Supply

7. Remove the Input/Output panel.
Related Links
Installing The Input/Output Panel
Installing The Input/Output Panel
1. Insert the Input/Output panel into the slot on the chassis front.
2. Slide the Input/Output panel towards the left of the computer to secure to the chassis.
3. Tighten the screw to secure the Input/Output panel to the chassis.
4. Connect the Input/Output panel or the FlyWire cable to the system board.
5. Install the front bezel.
6. Install the cover.
7. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing The Input/Output Panel
Removing The Power Supply
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Remove the PSU thermal sensor.
4. Disconnect the 4–pin power cable from the system board.
27