Installing the Heatsink
1. Place the heat sink on the system board.
2. Tighten the screws to secure the heatsink.
3. Install:
a. processor fan module
b. cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the PS2 and Serial Connector Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Perform the following steps as shown in the illustration:
a. Disconnect the cable from the PS2 and serial connector board [1].
b. Remove the screws that secure the PS2 and serial connector board to the base panel [2].
c. Slide and lift the PS2 and serial connector board away from the computer [3].
30
To Next Page
Loading...
