Dell OptiPlex 390 - Memory Module Service; Removing the Memory

DELL™ OPTIPLEX™ 390 TECHNICAL GUIDEBOOK —FINAL
21
COMMUNICATIONS - NETWORK ADAPTER (NIC) ( CONT.)
COMMUNICATIONS – INTEGRATED LAN
NOTE: MT supports full height (FH) cards and DT and SFF supports low profile (LP) cards.
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and
network infrastructure is required.
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and
network infrastructure is required.
INTEGRATED REALTEK® RTL8111E-VL
ETHERNET LAN 10/100/1000
MT DT SFF
Environmental
Operating temperature 0° C to 70° C (32° F to 158° F)
Operating humidity 20% to 80% (non-condensing)
Operating System Driver Support
Windows 7 32/64, Windows XP 32/64, Vista
32/64
Manageability (examples WOL, PXE) WOL, PXE 2.1
Broadcom NetXtreme 10/100/1000 PCIe Gigabit
1
Networking Card
MT DT SFF
Connector Type RJ45
Data Rates supported 10/100/1000 Mbps Half/Full duplex
Controller Details
Controller bus architecture (example PCIe 1.0a x1) PCIe c1.0a x1
Integrated memory 64KBytes RX, 8KBytes TX
Data transfer mode (example Bus-Master DMA) Bus-Master DMA
Power consumption (full operation per data rate connection speed) 2.84W (860mA @ +3.3V)
Power consumption (standby operation) Less than 300mW
IEEE standards compliance (example 802.1P) 802.3, 802.2, 802.3x, 802.1p
Hardware Certifications (example FCC, B, GS mark…) FCC B, VCCI B, CE
Boot ROM Support No
Network Transfer Mode (example Full Duplex, Half Duplex)
Network Transfer Rate (example 10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
10BASE-T (full-duplex) 20 Mbps Max*
100BASE-TX (half-duplex) 100 Mbps
Max*
100BASE-TX (full-duplex) 200 MbpsMax*
1000BASE-T (full-duplex) 2000 Mbps
Max*
* Depends on the system environment.