What to do if my Dell OptiPlex 5080 Small Form Factor Desktop displays 'Memory Allocation Error'?
If your Dell Desktop displays 'Memory Allocation Error', the software you are attempting to run is conflicting with the operating system, another program, or a utility. Shut down the computer, wait for 30 seconds, and then restart it. Run the program again. If the error message still appears, see the software documentation.
How to fix 'Memory Address Line Failure' on my Dell OptiPlex 5080 Small Form Factor Desktop?
A memory module may be faulty or improperly seated. Reinstall the memory module or, if necessary, replace it.
What does 'General Failure' mean on my Dell Desktop and how to fix it?
If your Dell Desktop displays 'General Failure', the operating system is unable to carry out the command. This message is usually followed by specific information, such as 'Printer out of paper'. Take the appropriate action based on the specific information provided.
What to do if my Dell Laptop has invalid memory installed?
Try resetting the memory module. If the problem persists, consider replacing the memory module.
How to fix BIOS recovery image found but invalid on Dell OptiPlex 5080 Small Form Factor Desktop?
If your Dell Desktop shows 'BIOS Recovery image found but invalid', flash the latest BIOS version. If the problem persists, replace the system board.
What to do if no memory/RAM is detected in my Dell Water Filtration System?
If your Dell Water Filtration System isn't detecting memory/RAM, first ensure the memory module is properly installed. If the problem continues, you may need to replace the memory module.
What to do if my Dell OptiPlex 5080 Small Form Factor displays 'Time-of-Day Clock Stopped'?
Connect your computer to an electrical outlet to charge the battery.
What does it mean if my Dell Desktop displays 'System fan failure'?
This message indicates that the system fan has failed.
What does it mean if my Dell Desktop displays 'CPU fan failure'?
This message indicates that the CPU fan has failed.
Why does my Dell OptiPlex 5080 Small Form Factor say 'CMOS checksum error'?
This message indicates that the RTC is reset, and the BIOS Setup default has been loaded.
To Next Page
General