Steps
1. Align and place the antenna modules in the slots on the middle frame.
2. Adhere the copper foil that secures the antenna cables to the middle frame.
3. Replace the two screws (M2x2.5) to secure the antenna modules to the middle frame.
4. Route the antenna cables through the routing guides on the display-assembly base.
Next steps
1. Install the speakers.
2. Install the rear-I/O bracket.
3. Install the bottom cover.
4. Install the wireless card.
5. Install the system-board shield.
6. Install the back cover.
7. Install the cable cover (optional).
Removing and installing components
121
To Next Page
Loading...
