Dell OptiPlex 5490 All-In-One - Installing the M.2 2280 Solid-State Drive;Intel Optane Memory Moduleinstalling the M.2 2280 Solid-State Drive

Steps
1. Remove the screw (M2x2.5) that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive from the M.2 card slot on the system board.
Installing the M.2 2280 solid-state drive/Intel Optane memory
moduleInstalling the M.2 2280 solid-state drive
Prerequisites
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2280 solid-state drive/Intel Optane memory module and provides a visual
representation of the installation procedure.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the
installation procedure.
Removing and installing components
45