Steps
1. Slide and align the middle frame to the slots on the display-assembly base, then snap the middle frame into place on the
display-assembly base.
2. Replace the 17 screws (M3x5) to secure the middle frame to the display-assembly base.
Next steps
1. Install the display panel.
2. Install the antenna modules.
3. Install the side-I/O board.
4. Install the PSU fan.
5. Install the PSU.
6. Install the microphones.
7. Install the power-button board.
8. Install the system board.
9. Install the camera assembly.
10. Install the speakers.
11. Install the rear-I/O bracket.
12. Install the bottom cover.
13. Install the wireless card.
14. Install the hard drive.
15. Install the system-board shield.
16. Install the back cover.
17. Install the cable cover (optional).
18. Install the stand.
19. Follow the procedure in After working inside your computer.
134
Removing and installing components
To Next Page
Loading...
