Dell OptiPlex 7040 - Mini Tower - Installing the Intrusion Switch; Removing the Power Switch

Installing the intrusion switch
1. Insert the intrusion switch into the slot on the computer.
2. Route the intrusion switch cable through the fan grommet.
3. Connect the intrusion switch cable to the connector on the system board.
4. Install the:
• bezel
• cover
5. Follow the procedure in After Working Inside Your Computer.
Removing the power switch
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
• cover
• bezel
3. Open the front bezel door.
4. To remove the power switch:
a. Disconnect the power switch cable from the system board [1].
b. Unroute the power switch cable from the retention clip.
c. Press the release tab [2] and slide the power switch out of the computer [3].
21