4 Install the:
a Heat sink fan
b Hard drive and optical drive module
c HDD assembly
d Front bezel
e Side cover
5 Follow the procedure in After working inside your computer.
Intrusion switch
Removing intrusion switch
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Side cover
b Front bezel
c HDD assembly
d Hard drive and optical drive module
e Heat sink fan
f Heat sink
3 To remove the intrusion switch:
a Disconnect the intrusion switch cable from the connector on the system board [1].
b Slide the intrusion switch and lift it away from the system [2].
42
Disassembly and reassembly
To Next Page
Loading...
