2. Remove the side cover.
3. Remove the front bezel.
4. Remove the fan assembly.
About this task
The following images indicate the location of the heat sink and provide a visual representation of the removal procedure.
Steps
1. Loosen the three captive screws that secure the heat sink to the system.
NOTE: Loosen the screw in the sequential order (1,2,3) as printed on the heat sink.
2. Lift the heat-sink from the system board.
Installing the heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
36
Disassembly and reassembly
To Next Page
Loading...
