Dell OptiPlex 780 Ultra Small Form Factor - Removing the I;O Panel

Back to Contents Page
I/O Panel
Dell™ OptiPlex™ 780 Ultra Small Form Factor—Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage
at www.dell.com/regulatory_compliance.
Removing the I/O Panel
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your Computer
.
2. Remove the cover
.
3. Remove the front bezel
.
4. Remove the drive cage
.
5. Disconnect the I/O panel data cable from the system board.