Back to Contents Page
Power Supply
Dell™ OptiPlex™ 780 Ultra Small Form Factor—Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage
at www.dell.com/regulatory_compliance.
Removing the Power Supply
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your Computer
.
2. Remove the cover
.
3. Remove the front bezel
.
4. Remove the drive cage
.
5. Remove the intrusion switch
.
6. Remove the heat sink and processor
.
7. Disconnect the power cables from the system board.
To Next Page
Loading...
