6-12 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide
5HSODFH WKHFRPSXWHUFR YHUUHF RQQ HFW \RX UFR PSXWHUDQ GSHULSKHUDOV
WRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
As the system boots, it detects the presence of the new video memory and auto-
matically changes the system configuration information in the System Setup
program.
( QW HUW KH6\VWHP6HWX SSURJUDPFRQILUPW KDW WKHDPRXQWRIYLGHR
PHPR U\GLVSOD\HGLQW KH9LGHR0HPRU\FDWHJRU\LV0%DQGUHVHW
& KDVVLV,QWUXVLRQW R1RW'HWHFW HG
See Chapter 2, “Using the System Setup Program.”
If the video memory total is incorrect, turn off the system, remove the computer
cover, and reseat the video-memory upgrade module in its socket.
5XQWKH9LGHR7HVW* URXSLQWKH'HOO'LDJQRVWLFVWRW HVW WKHQHZYLGHR
PHPRU\
See your
Diagnostics and Troubleshooting Guide
for instructions on running the
Dell Diagnostics and troubleshooting any problems that occur.
8SJUDGLQJWKH0LFURSURFHVVRU
To take advantage of future options in speed and functionality, you can replace the
microprocessor on your system board with any Dell-supported microprocessor
upgrade. Call your Dell sales representative for information on available micro-
processor upgrades.
The microprocessor upgrade kit includes a new single-edge contact (SEC) cartridge
(SEC) with heat sink assembly and an airflow shroud.
The following procedure describes how to replace the microprocessor.
NOTE: Dell recommends that only a technically knowledgeable person perform this
procedure.
&$87,216HH´3URWHFWLQJ$JDLQVW(OHFWUR VW DWLF'LVFKDUJHµLQWKHVDI HW\
LQVW UXFW LR QVDW W KHIUR QWR IWKLVJXLGH
5HPRYHWKHFRPSXWHUFRYHUDFFRUGLQJWRWKHLQVWUXFWLRQVLQ´5HPRYLQJ
W KH &RPSXWHU&RYHUµLQ&KDSWHU
5RWDWHWKHSR ZHUVX SSO\ R XWRIWKHZD\DFF RUGLQJW RWKHLQVW UXFW LR QVLQ
´ 5RWDWLQJW KH3RZHU6XSSO\ $ZD\)URPWKH6 \VWHP%R DUGµLQ
& KDSWHU