Dell OptiPlex GX1 - Page 109

Installing System Board Options 6-13
:$51,1*7KH6(& FDUWULGJHDQGKHDW VLQNFDQJHWH[WUHPHO\KRWGXULQJ
V\VWHPRSHUDWLRQ%HVXUHWKHDVVHPEO\KDVKDGVXIILFLHQWWLPHWRFRRO
EHIRUH\RXWRXFKLW 
  6 HH)LJXUHWRORFDWHWKH6(&F DUWULGJHFRQQHFWRUODEHOHG´6/27µ 
R QWKHV\VWHPER DUG
  3UHVVRXWZDUGRQDQGKROGRQHRIWKHJXLGHEUDFNHWWDEVJUDVSWKH
KHDWVLQNDWW DFKHGWRW KH6( &F DUWULGJHDQGWKHQURWDW HW KH6(&FDU
WULGJHKHDWVLQNDVVHPEO\XSDQGRXWRILWVFRQQHFWRURQWKHV\VWHP
ERDUG
You must use up to 15 pounds of force to disengage the SEC cartridge from the
connector.
)LJXUH5HPRYLQJWKH0LFURSURFHVVRU
  ,QVHUW WKHQHZ6(&FDUWULGJH KHDWVLQNDVVHPEO\LQW RW KHV\VWHPER DUG
FRQQHFWRU
Press the SEC release latches outward until they snap into position. Orient the
assembly with the heat sink facing toward the right (as you face the front of the
chassis), and press the SEC firmly into its connector until it is fully seated. You
must use up to 25 pounds of force to fully seat the SEC cartridge/heat sink
assembly in the connector.
  ,I\RXUXSJUDGHNLWLQFOX GHGDQDLUIORZVKURXGLQVWDOOLWRYHUWKH6 (&
FDU WULGJH KHDWVLQNDVVHPEO\
tabbed guide-bracket
assembly
tabs (2)
connector
heat sink
SEC cartridge