Dell OptiPlex GX1 - System Board Labels

Inside Your Computer: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
file:///C|/infodev/2013/eDoc/OpGX1/UG/inside.htm[2/21/2013 11:47:19 AM]
Password features are disabled.
BIOS (default) Reserved (do not change)
BUS66M (default) Reserved (do not change)
266MHZ* (default) Reserved (do not change)
300MHZ* (default) Reserved (do not change)
333MHZ* (default) Reserved (do not change)
350MHZ* (default) Reserved (do not change)
400MHZ* (default) Reserved (do not change)
450MHZ* (default) Reserved (do not change)
500MHZ* (default) Reserved (do not change)
*
The correct microprocessor speed is automatically detected and set by the system. Do not change the
settings of these jumpers.
The system can operate with a microprocessor speed up to 600 MHz.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in your online System
User's Guide.
jumpered unjumpered
System Board Labels
Table 2 lists the labels for light-emitting diode (LED) indicators, connectors, and sockets on the system
board, and it gives a brief description of their functions.
Table 2. System Board Indicators, Connectors, and Sockets
Connector or
Socket
Description
AMC ATI multimedia channel
BATTERY Battery socket
CD_IN CD-ROM audio interface connector
DIMM_x DIMM socket
DSKT Diskette/tape drive interface connector
ENET NIC connector (optional)
FAN Microprocessor fan connector
HDLED Hard-disk drive LED connector (on riser board)
IDEn EIDE interface connector
INTRUSION Chassis intrusion switch connector