Dell OptiPlex GX1 - Page 136

Messages and Codes: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
file:///C|/infodev/2013/eDoc/OpGX1/UG/messages.htm[2/21/2013 11:47:24 AM]
Table 2. System Beep Codes
Code Cause Action
1-1-2 Microprocessor register
failure
See "Getting Help
" for instructions on obtaining technical assistance.
1-1-3 NVRAM Run the System Set Test Group in the Dell Diagnostics.
1-1-4 ROM BIOS checksum
failure
Run the System Set Test Group
in the Dell Diagnostics, if possible.
1-2-1 Programmable interval
timer
Run the System Set Test Group in the Dell Diagnostics, if possible.
1-2-2 Direct memory access
(DMA) initialization
failure
Run the System Set Test Group
in the Dell Diagnostics, if possible.
1-2-3 DMA page register
read/write failure
Run the System Set Test Group
in the Dell Diagnostics, if possible.
1-3 Video Memory Test
failure
Run the Video Test Group in the Dell Diagnostics.
1-3-1
through
2-4-4
DIMMs not being
properly identified or
used
See "Troubleshooting System Memory
."
3-1-1 Slave DMA register
failure
Run the System Set Test Group
in the Dell Diagnostics, if possible.
3-1-2 Master DMA register
failure
Run the System Set Test Group in the Dell Diagnostics, if possible.
3-1-3 Master interrupt mask
register failure
See "Getting Help" for instructions on obtaining technical assistance.
3-1-4 Slave interrupt mask
register failure
See "Getting Help" for instructions on obtaining technical assistance.
3-2-2 Interrupt vector loading
failure
See "Getting Help" for instructions on obtaining technical assistance.
3-2-4 Keyboard Controller
Test failure
Run the Keyboard Controller Test in the Dell Diagnostics.
Otherwise, see "Getting Help
" for instructions on obtaining technical
assistance.
3-3-1 NVRAM power loss Run the System Set Test Group
in the Dell Diagnostics, if possible.
3-3-2 NVRAM configuration Run the System Set Test Group
in the Dell Diagnostics, if possible.
3-3-4 Video Memory Test
failure
Run the Video Test Group
in the Dell Diagnostics.
3-4-1 Screen initialization
failure
Run the Video Test Group in the Dell Diagnostics.