Figure 25. System Board PSWD Jumper
Jumper pins are small groups of two or more pins on a circuit board. Plastic jumpers containing a wire fit down over the pins. The wire connects
the pins and creates a circuit.
NOTICE: Make sure your system is turned off before you change a jumper setting. Otherwise, damage to your system or
unpredictable results may occur.
To change a jumper setting, pull the jumper off its pin(s) and carefully fit it down onto the pin(s) indicated.
Dell shipped your computer with a PSWD jumper installed, meaning that password features for this computer system are enabled. When you
remove the jumper, or when you install the jumper on only one of the two pins, the password features for this computer system are disabled.
System Board Labels
Table 1 lists the labels for connectors and sockets on your system board and gives a brief description of their functions.
Table 1. System Board Connectors and Sockets
Expansion Cards
The mini tower GX100 chassis can accommodate up to five 32-bitPCIexpansioncards.Figure26 shows an example of a 32-bit PCI expansion
card.
Figure 26. 32-Bit PCI Expansion Card Example
To Next Page
Loading...
