Personal System/2 (PS/2)-
style keyboard
6-pin mini-Deutsche Industrie Norm (DIN)
Universal Serial Bus (USB)
two USB-compliant connectors
Primary EIDE hard-disk drive
40-pin connector on PCI local bus
Secondary EIDE hard-disk
drive
40-pin connector on PCI local bus
restarts (reboots) the system
toggles microprocessor speeds on 101-key keyboard (in MS-DOS®real mode only)
toggles microprocessor speeds on 102-key keyboard (in MS-DOS real mode only)
<F2> or <Ctrl><Alt><Enter>
starts embedded System Setup (during power-on self-test [POST] only)
automatically starts (boots) the system from the network environment specified by the managed boot
agent (MBA) rather than from one of the devices in the System Setup Boot Sequence option
launches the utility partition (if installed) during system start-up
push button (no reset button on small-form-factor systems)
green light-emitting diode (LED) on riser board; blinking green on the front panel indicates sleep
state; dual-color LED on front panel—green for power, yellow for diagnostics
Hard-disk drive access indicator
Link integrity indicator (on optional
integrated NIC connector)
green LED for 10-Mb operation; orange LED for 100-Mb operation
Activity indicator (on optional integrated
NIC connector)
small-form-factor chassis: 110 watts (W);
low-profile chassis: 145 W;
mini tower chassis: 200 W
small-form-factor chassis: 808 British thermal units (BTU)/hour (hr) (nominal);
low-profile chassis: 808 BTU/hr (nominal);
mini tower chassis: 913 BTU/hr (nominal)
90 to 135 volts (V) at 60 hertz (Hz); 180 to 265 V at 50 Hz
To Next Page
Loading...
