1 release lever
2 microprocessor
3 socket
10. Remove the microprocessor from the socket.
Leave the release lever extended in the release position so that the socket is ready for the new microprocessor.
Installing the Microprocessor
NOTICE: You must position the microprocessor correctly in the socket to avoid permanent damage to the
microprocessor and the computer.
1. If the release lever is not extended to the release position, move it to that position.
2. Align pin 1 (the imprinted corner) of the microprocessor and pin 1 of the socket.
Microprocessor Installation
To Next Page
Loading...
