1. Disconnect the power and data cables from the CD/DVD drive located above the floppy drive.
2. Disconnect the power and floppy-drive cables from the back of the floppy drive.
3. Disconnect the floppy-drive cable from the system board connector (labeled DSKT).
Removing Power and Drive Cables
1 power cable
2 floppy-drive cable
3 floppy-drive connector (DSKT)
4. Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it from the floppy-drive
bay.
Floppy Drive Removal
To Next Page
Loading...
