Operating the monitor │ 53
When the monitor goes into power-save mode, the following message appears:
Activate the computer and wake up the monitor to gain access to the OSD.
NOTE: The message may be slightly different according to the
connected input signal.
The OSD functions only in the normal operatio
n mode. If you press any button other
than the power button during the Active-off mode, the following message will
appear depending on the selected input:
Activate the computer and the monitor to gain access to the OSD.
NOTE: The message may be slightly different according to the
connected input signal.
If either VGA, DVI-D, DisplayPort, or HDMI input is
selected and the corresponding
cable is not connected, a floating dialog box as shown below appears.
NOTE: The message may be slightly different according to the
connected input signal.
To Next Page
Loading...
